If you haven't installed the Section3D subassembly click on the button below to view How to Install Section3D Subassembly:



CondFillSlopes-Completed.dwg : Sample Civil 3D (2010) Dwg File used for this tutorial

CondFillSlopes-Qty.dwg : Completed Civil 3D (2010) dwg file with Fill Qunatity and the tables

Full-S3D-Template.zip : Section3D Full Template (fully reusable and modifiable) created in this tutorial

This is another conditional subassembly example based on the fill height (5 meter in this case). The difficulty level is basic and therefore no step-by-step instructions are provided other than the template file. Please study the Section3D code provided after loading the full template file (Full-S3D-Template.tpl) in Section3D, and try to adjust the alignment or profile followed by rebuilding the corridor. If you have completed the pevious Section3D exercises you would understand the flow of logic. This template does not take care of the cut condition since the profile of the road centerline is assumed always above the existing ground. However, it would take another couple of minutes to add the cut ditches if you study the code carefully.